Table of Contents
Advertisement
Secure the secondary PCIe riser cage full-length expansion board retainer (on page 33).
o
Install the access panel (on page 25).
17.
Install the server in the rack
18.
Remove any installed hard drives
19.
Install a SATA hard drive
20.
5.
Install hard drive blanks in any empty hard drive bays.
21.
Connect each power cord to the server.
22.
Connect each power cord to the power source.
23.
Power up the server (on page 23).
24.
Use RBSU
25.
P420i Controller, if necessary.
150W PCIe power cable option
CAUTION:
remove all AC power cords before removing or installing the PCI expansion cage.
Connect the cable as indicated.
("Installing the server into the
("Removing a hot-plug SAS or SATA hard
("Installing a hot-plug SAS or SATA hard
("HP ROM-Based Setup
To prevent damage to the server or expansion boards, power down the server and
rack" on page 40).
Utility" on page 103) to disable the embedded HP Smart Array
drive" on page 60).
drive" on page 59) in hard drive bay
Cabling 97
Advertisement
Table of Contents
