150W Pcie Power Cable Option - HP ProLiant DL380p User Manual

Connect the remaining chipset SATA cable connector to the SATA header on the hard drive cage.
b.
Coil the cables behind the hard drive backplane to minimize airflow impact.
11.
Install the fan cage.
12.
Install the air baffle
13.
Install the PCI riser cage (on page 30), if removed.
14.
Secure any full-length PCI expansion boards with the retaining latch on the air baffle
15.
full-length expansion board
Install the access panel (on page 25).
16.
Install the server in the rack
17.
Remove any installed hard drives
18.
Install a SATA hard drive
19.
5.
Install hard drive blanks in any empty hard drive bays.
20.
Connect each power cord to the server.
21.
Connect each power cord to the power source.
22.
Power up the server (on page 23).
23.
Using the HP ROM-Based Setup Utility (on page 103), disable the embedded HP Smart Array P420i
24.
Controller, if necessary.

150W PCIe power cable option

CAUTION:
remove all AC power cords before removing or installing the PCI expansion cage.
("Remove the air baffle" on page 32).
retainer" on page 31).
("Installing the server into the
("Removing a hot-plug SAS or SATA hard
("Installing a hot-plug SAS or SATA hard
To prevent damage to the server or expansion boards, power down the server and
rack" on page 38).
drive" on page 56).
drive" on page 55) in hard drive bay
("Secure the
Cabling 96