Medium And High Power Radiators - Bosch Integrus Operation Manual

Language Distribution System
5.3

Medium and High Power Radiators

Radiators in permanent installations can be either fixed to a wall, hung under a ceiling or
balcony or secured to any sturdy material, using the suspension bracket supplied with the
radiator. The mounting angle can be adjusted for optimal coverage. For wall mounting a
separate bracket (LBB 3414/00) is also required. In non-permanent installations, a floor stand
can be used.
Warning!
When you install the radiator in a ceiling, you must leave at least 1 m
the back of the radiator. To prevent the radiator from becoming too hot, make sure that there
!
is a good airflow in this free space.
Always ensure that natural airflow is not obstructed by ceilings, walls etc. when determining
the position of the radiator. Leave plenty of space around the radiator to prevent it becoming
too hot.
Follow the instructions below to mount a radiator:
1.
2.
3.
4.
Bosch Security Systems B.V.
Attach the mounting plate to the suspension bracket, see section Attach mounting plate to
the suspension bracket, page 36
Attach the suspension bracket to the radiator, see section Attach the suspension bracket,
page 37
Do one of the following:
Mount the radiator on a floor stand, see section Mount radiator on a floor stand, page 37
Mount the radiator on a wall, see section Mount radiator on a ceiling, page 40
Mount the radiator on the ceiling, see section Attach mounting plate to the suspension
bracket, page 36
Mount the radiator on top of a horizontal surface, see section Mount radiator on horizontal
surfaces, page 40
Secure the radiator with a safety cord, see section Secure the radiator with safety cord.,
page 40
Operation manual
Installation | en 35
of free space around
3
2013.11 | V1.4 |