Bosch Integrus Operation Manual page 34

34 en | Installation
Figure 5.3: Mounting of the module in the transmitter housing
Follow the instructions below to mount the module in the transmitter housing. The numbers
refer to the two figures above.
Danger!
Before opening the transmitter housing, make sure that the mains power and all other
connections are disconnected!
Warning!
ICs and many other electronic components are susceptible to electrostatic discharge (ESD).
!
Take preventive measures when handling the interface modules. Keep the PCBs as long as
possible in their protective packing. Wear an anti-ESD bracelet.
1.
2.
3.
4.
5.
6.
Warning!
!
To prevent damage to the PCB connectors (4), be sure that the connectors are aligned
properly before pushing the module in.
2013.11 | V1.4 |
2
5
4
Remove the top cover of the transmitter housing.
Remove the module slot cover (1) at the back of the transmitter. Keep the screws (2).
Insert the module (3) (with the components faced down) into the transmitter housing
and push it firmly into the PCB connector (4).
Fasten the slot cover (5) to the back of the transmitter housing. Use the screws (2) from
step 2.
Fasten the module's PCB to the distance studs (6). Use the screws (7) provided with the
module.
Close the transmitter housing.
3
7
6
Operation manual
Language Distribution System
Bosch Security Systems B.V.