Disable Or Enable Carriers (4G); View Carrier Assignments (4H) - Bosch Integrus Operation Manual

56 en | Configuration
Menu Item
7.2.8

Disable or enable carriers (4G)

Normally the channels are automatically assigned to the available carriers. However, when the
reception quality of a specific carrier is not good, that carrier can be disabled manually. The
channels are then automatically re-assigned to the next available carriers. Each of the 8
carriers (0 to 7) can be disabled or enabled in the Carrier Settings menu (4G).
Menu Item
4G C.Settings ...
4G Carrier n
Notice!
In case the receiver is set to start with number 1, the channel numbers in the receiver will be
shown with an offset of 1 compared to the transmitter.
7.2.9

View carrier assignments (4H)

With menu option 4H the carrier assignment can be seen, i.e. which channels are transmitted
on each carrier. Note that the number of channels that can be distributed on one carrier
depends on the chosen quality mode. See examples below.
Channels 4, 5, 6, and 7
(all Mono MQ) are
assigned to carrier 1.
Menu Item
4H C.Overview ...
4H Carrier n
2013.11 | V1.4 |
Options
- 'Audio', 'Radio', 'TV',
'Info'
- language names
Options
Carrier nr.:
0 ... 7
Status:
- Disabled
* - Enabled
Channels 16 and 17 (both Mono
MQ) are assigned to carrier 4.
Room for more channels on same
carrier.
Options
Carrier nr.:
0 ... 7
Operation manual
Language Distribution System
Description
Choose these names when the system is used
for music distribution.
Choose from pre-programmed language
names (list shows abbreviation and the
English name of the language).
Description
Push the button to go to the sub-menu.
Select which carrier to configure.
The selected carrier is disabled (off).
The selected carrier is enabled (on).
Channels 18 and 19 (both Mono
PQ) are assigned to carrier 5.
Description
Push the button to go to the sub-menu.
Select which carrier to view.
Bosch Security Systems B.V.