Installation; Countertop Installation - Follett E7CI100A Installation, Operation And Service Manual

Installation ––––––––––––––––––––––––––––––––––––––––––––––––––––––
CAUTION!
No service or maintenance should be performed until the technician has thoroughly read this
service manual. Except for routine cleaning and sanitizing, only qualifi ed technicians should attempt
to service or maintain this equipment.

Countertop Installation

Installation instructions for freestanding model may be found on
page 8.
1. A clearance of at least 77 mm (3") is required behind and
on each side of the dispenser for electrical connection and
ventilation (Fig. 1).
2. Rough-in the electrical service and water line.
§ Electrical: 230V, single phase. The dispenser is provided with
a 2.4 m (8 ft.) power cord with choice of CEE 7/7, AS 3112, or
BS 1363 plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" MPT inlet.
NOTICE!
If installing optional Drip Tray Drain Kit or Leg Accessory,
complete those steps before proceeding. Refer to instructions
included with the Drip Tray Drain Kit, or see
Leg Accessory instructions.
3. Connect water line. Recommended routing (Fig. 2) allows easy
access to water for cleaning and sanitizing procedure.
4. If installing the optional internal water fi lter*, please see
Optional Internal Water Filter Installation on page 10
before proceeding. If not, proceed to step 5.
* If your dispenser has the internal water fi lter option, the water fi lter must
be installed for the dispenser to operate. Because internal components will
need to be accessed for both procedures, Follett recommends installing the
water fi lter just prior to initial sanitizing.
5. Connect power supply.
6. Sanitize the dispenser prior to use (see
Sanitizing on page
Cleaning and
13).
page 8 for
Dispenser and Ice machine E7CI100A/E7FS100A
Fig. 1
countertop models
minimum 77 mm (3")
clearance required
Fig. 2
91.4 cm (3')
Plug
Valve
1/4" MPT
7