Follett E7CI100A Installation, Operation And Service Manual page 9

Installation
(continued)
3. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
4. Attach dispenser to base stand with supplied hardware (Fig. 5).
NOTICE!
If installing optional Drip Tray Drain Kit, refer to instructions
included with the Drip Tray Drain Kit.
5. Connect water line. Recommended routing (Fig. 6) allows easy
access to water for cleaning and sanitizing procedure.
6. If installing the optional internal water fi lter*, please see
Optional Internal Water Filter Installation on page 10
before proceeding. If not, proceed to step 7.
* If your dispenser has the internal water fi lter option, the water fi lter must
be installed for the dispenser to operate. Because internal components will
need to be accessed for both procedures, Follett recommends installing the
water fi lter just prior to initial sanitizing.
7. Connect power supply.
8. Sanitize the dispenser prior to use (see
Sanitizing on page
–––––––––––––––––––––––––––––––––––––––––––––––
Cleaning and
13).
Fig. 5
Fig. 6
91.4 cm (3')
Dispenser and Ice machine E7CI100A/E7FS100A
X4
Plug
Valve
1/4" MPT
9