Flex™ Source Select; Flex Dve1 (Pip1) And Dve2 (Pip2); Dve Position; The Enable Option - Datavideo SE-3000 Instruction Manual

Flex™ Source Select
Along the bottom of the initial Flex™ menu screen you can select a part of the Flex™ image and then use
the AUX BUS row of buttons to assign a source.

Flex DVE1 (PiP1) and DVE2 (PiP2)

Tapping on DVE1 or DVE2 in the yellow menu area
changes the Touch Screen Options. DVE1 or 2 can
be set up as a PiP or Picture in Picture element of
the Flex™ output.
Displayed options for DVE1 or 2 are DVE Size,
DVE Border, DVE Crop and DVE Position.

DVE Position

The Position options and values are currently shown along the bottom of the display.

The Enable option

in the bottom right hand corner toggles the currently selected DVE1 or DVE2 either
On or Off. So you could switch DVE1 (PIP1) off and only have the background image and DVE2 (PIP2).

The Rotation value

shows the amount of rotation that has been applied to the selected DVE1 or DVE2
image. The Flex Src DVE1 screen (above) has an image which shows the selected DVE (PIP) window in
relation to the main background image. The larger box is the background image and the smaller box is the
DVE (PIP) image. Over the top of the smaller DVE (PIP) box is an arrow which shows which way this image
has been rotated. The arrow indicates the normal top edge of the DVE (PIP) image. If the arrow is pointing to
the side then the DVE (PIP) image displayed in the Flex output will also be on its side.
Turning the F4 Function Dial next to the Touch Screen on the SE-3000 Control Panel will change the
rotation value. Alternatively you could tap on the option within the Touch Screen Panel and then enter a value
using the numeric keypad. Or you could press the ROT button in the Joystick area of the Control Panel
and then twist or rotate the joystick handle in the direction required. Pressing the FINE button allows fine
or small adjustments to be made. Press the NORM button and the selected DVE (PIP) image returns back
to the factory default position and values. Use the FLEX1 and FLEX2 buttons in the joystick area to switch
between adjustments of the DVE1 & 2 (PIP) images.

The X and Y values

change the location of the DVE (PIP) image. The X value moves the image left and
right. The Y value moves the image up and down. The DVEs in the Flex Source Processor are 2D DVEs,
and do not allow the DVE (PIP) to be rotated in X, or Y, or have a Perspective feel.
33