Motion Detection - Beward N13201 Operation User's Manual


Always: an alarm event is always active.

Schedule: an alarm event will be active only according to the schedule (see
paragraph 11.6).
NOTE:
To save changes press the [Save] button, to cancel changes press the [Cancel] button.

11.2.1.1. Motion Detection

Motion Detection: the action is executed when motion detector triggers (Pic. 11.27).
Adjust this trigger properly and you will be able not only to save your hard drive free space
but, moreover, to optimize your data operation in future (by viewing only the records where motion
was detected).
When selecting this event type the following settings are available.
Set min time interval between triggers: when this time interval ends, the alarm event can
be restarted. The values from 1 to 999 seconds are available.
Detection Area: select a zone for detection.
To set motion detection go to SETTING – Event – Motion Detection (see paragraph 11.3).
Detection Type: specify the moment of alarm event triggering:
Start: an alarm triggers at the moment when the motion starts.
Stop: an alarm triggers at the moment when the motion ends.
Please Configure Motion Detection: a link which allows you to open motion detection
configuration window.
To get a clear idea of data recording process triggered by motion detection with the [Start]
detection type, please, look at the Picture 11.28:
Let the [Pre-event Recording] time is 3 seconds and the [Post-event Recording] time is
6 seconds. Because of such values it is required to specify the "minimum time interval between
N13201 Operations User Manual
Chapter 11. The [SETTING] Menu: Event
Pic. 11.27
Pic. 11.28
90