Using The Phonak Microlink Mlxs With The Iconnect; Figure 31. Attaching The Mlxs To The Iconnect; Figure 32. Turning On The Mlxs - Advanced Bionics HARMONY User Manual

Using the Phonak MicroLink MLxS With the iConnect

To use the MLxS receiver with the iConnect, follow these steps:
• Turn off the MLxS receiver.
• Attach the MLxS receiver to the iConnect by lining up the thicker pin with
the wider socket hole. Forcing the pins into the holes will result in damage
to the unit.
Figure 31: Attaching the MLxS to the iConnect.
• Attach the iConnect by aligning it to the processor post and gently pushing
straight in until it lightly clicks in place.
• Operate the MLxS by turning on the FM transmitter, then the MLxS, and fi nally
the Harmony. Use the 1-dot setting for the MLxS.
Figure 32: Turning On the MLxS.
• To use the iConnect, the processor must contain a program set up for auxiliary
input. A 50/50 or 30/70 Mic/Aux mix is recommended for use in the classroom.
Switch to this program when using the processor with the iConnect. Please
contact your audiologist for fi tting advice if necessary.
• To remove the iConnect, fi rst turn off the MLxS. Then turn the earhook slightly
more than
1 /4
turn in either direction until it pops off.
User Guide for the Auria Harmony Sound Processor 39