Advantech UTC-520A User Manual page 40

(1-2)*
(3-4)
(5-6)
J6
Part Number
Footprint
Description
Setting
(1-2)*
(2-3)
4.2.1.3 Jumper Description
Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, you
connect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2 and 3. In this case you would connect either
pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers to clear CMOS. Before turning on the power sup-
ply, set the jumper back to 3.0 V Battery On.
UTC-520A/B User Manual
RS232
RS485
RS422
Clear CMOS
1653003101
HD_3x1P_79_D
PIN HEADER 3x1P 2.0mm 180D(M) DIP 2000-13 WS
Function
Normal
Clear COMS
32