3.1 Introduction
The UTC-520A/B consists of a PC-based computer that is housed in an Aluminum
extrusion. You can install a HDD, DRAM, and Compact Flash by removing the rear
cover. Any maintenance or hardware upgrades can be easily completed after remov-
ing the rear cover.
Warning! Do not remove the rear cover until you have verified that no power is
flowing within the UTC-520A/B. Power must be switched off and the
power cord must be unplugged. Every time you service the UTC-520A/
B, you should be aware of this.
3.2 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one Serial Advanced Technology Attachment (SATA) hard disk drive
to the UTC-520A/B's internal controller. The SATA controller supports faster data
transfer and allows the SATA hard drive to exceed 150 MB. The following are instruc-
tions for installation:
1.
Detach and remove the rear cover.
2.
Place the HDD in the metal bracket, and tighten the screws (see Figure 3.1).
3.
The HDD cable (SATA 7P+1*5P-2.5/SATA(15+7)P) is next to the metal brace.
Connect the HDD cable to the motherboard. Plug the other end of the cable into
the SATA hard drive. 520A: CN6 (SATA signals) + CN4 (SATA power); 520B:
CN14 (SATA signals) + CN15 (SATA power).
4.
Put the rear cover on and tighten the screws.
UTC-520A/B User Manual
Figure 3.1 Installing primary 2.5" HDD
14