Upload Firmware Image And Configuration File - Fujitsu PRIMERGY BX900 Configuration Manual

2.4

Upload Firmware Image and Configuration File

This section will describe how to upload the FW and configuration file from Ethernet
Connection Blade.
Beginning in privileged EXEC mode, follow these steps to upload firmware from Ethernet
Connection Blade:
Command
Step 1 copy image <filename> <url>
To upload a firmware, use copy image privileged EXEC command.
In this example, a firmware will be uploaded via TFTP protocol to a TFTP server with IP
address 192.168.2.100.
Before performing the upload operation, you have to configure an IP address for
!
your Ethernet Connection Blade via DHCP protocol or manually.
(BX900-CB1)#
copy image sb11a-sw-r-0.30.0213.biz tftp://192.168.2.100/sb11a-sw-r-0.30.0213.img
Mode........................................... TFTP
Set TFTP Server IP............................. 192.168.2.100
TFTP Path...................................... ./
TFTP Filename.................................. sb11a-sw-r-0.30.0213.img
Data Type...................................... Code
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n)y
TFTP code transfer starting
File transfer operation completed successfully.
(BX900-CB1)#
2011 Fujitsu Technology Solutions
©
Purpose
To upload firmware specified in
<filename> to the <url> address where
<url>={xmodem | tftp://ipaddr/path/file |
ftp://user:pass@ipaddr/path/file}
15