Configuring Port Groups - Fujitsu PRIMERGY BX900 Configuration Manual

6

Configuring Port Groups

The downlink ports of Ethernet Connection Blade can be combined into Port Groups. Port
Groups have the following characteristics:
1. Each Port Group can contain only internal server ports (INT1-INT36).
2. It is not mandatory to include an uplink set. A group without a configured uplink set is used
only for internal communication.
3. Communication between groups is not possible, nor is traffic from one group visible in
another group.
By default there is no traffic between ports of different port groups except over
!
Service VLAN and Service LAN.
All ports in a Port Group have the same configuration. Each port in the Port Group is a member
of a unique, untagged/tagged VLAN.
In the port groups, it is VLAN transparent; the packet will be forwarded as it is received on
ingress side, including the VLAN tagging.
Beginning in privileged EXEC mode, follow these steps to create port group and assign ports
to this port group:
Command
Step 1 configure
Step 2 port-group portGroupName
[uplinkSetName]
Step 3 interface interface-id
Step 4 no port-group
Step 5 port-group portGroupName
Step 6 exit
Step 7 exit
Step 8 show port-group [portGroupName]
To create a port group, use port-group global configuration command. To add/remove an
interface to a port group, use port-group/no port-group interface configuration command.
To display the port group, use show port-group privileged EXEC command.
2011 Fujitsu Technology Solutions
©
Purpose
Enter global configuration mode.
To create a port group with an assigned
group name and/or an assigned uplink
set.
Specify the internal physical port that you
want to set to be a member of the port
group, and enter interface configuration
mode.
Remove this interface from the port group
if it is already configured to a port group.
To add this interface to the specified port
group.
Return to global configuration mode.
Return to privileged EXEC mode.
Verify the configuration.
27