Configuring Load Balance Of Link Aggregation - Fujitsu PRIMERGY BX900 Configuration Manual

11.3

Configuring Load Balance of Link Aggregation

This section describes how to configure link aggregation with load balance settings.
Beginning in privileged EXEC mode, follow these steps to configure link aggregation with load
balance settings:
Command
Step 1 configure
Step 2 interface interface-id
Step 3 load-balance
<dst-ip/dst-mac/src-dst-ip/src-dst-mac/
src-ip/src-mac>
Step 4 exit
Step 5 exit
Step 6 show port-channel all
To set the load balance setting of a port-channel group, use load-balance interface
configuration command. To display port-channel group, use show port-channel all
privileged EXEC command.
In this example, a port-channel group downlink-lag1 is set to use source IP and
destination IP for its load balance setting.
(BX900-CB1)#configure
(BX900-CB1)(Config)#port-channel downlink-lag1
Interface BX900-CB1/1/3 created for port-channel downlink-lag1
(BX900-CB1)(Config)#interface BX900-CB1/1/3
(BX900-CB1)(Interface BX900-CB1/1/3)#load-balance src-dst-ip
(BX900-CB1)(Interface BX900-CB1/1/3)#exit
(BX900-CB1)(Config)#exit
(BX900-CB1)#show port-channel all
Port-
Log. Channel
Intf Name
------ ---------------
BX900-CB1/1/3 downlink-lag1
Link
Adm. Trap STP
Link Mode Mode Mode Type LB Ports
------ ---- ---- ------
Down En. En. En.
2011 Fujitsu Technology Solutions
©
Purpose
Enter global configuration mode.
Specify the port-channel interface (logical
interface), and enter interface
configuration mode.
Set the load balance for the port-channel
group.
Return to global configuration mode.
Return to privileged EXEC mode.
Verify the configuration.
Mbr
---- --- ------
St. SDI BX900-CB1/0/1 Auto
BX900-CB1/0/2 Auto
BX900-CB1/0/3 Auto
Port Port
Speed Active
--------- ------
False
False
False
42