Panasonic AJ-PD500P Operating Instructions Manual page 89

Item
Sets the time code to use when an external time code is used.
EXT LTC: LTC of TIME CODE IN connector.
SLTC: LTC information added to the serial signal input to the SDI IN connector.
SVITC: VITC information added to the serial signal input to the SDI IN connector.
EXT TC SEL
Note:
When "SLTC" or "SVITC" is set and "SD SDI" is selected as the input signal, the VITC of
the input video signal is used.
Sets the drop frame mode or non-drop frame mode for CTL and TCG.
DF MODE DF: Uses drop frame mode.
NDF: Uses non-drop frame mode.
Selects whether to output VITC signals at the positions specified in the "VITC POS-1" and
"VITC POS-2" menu items during playback.
BLANK: Does not output a VITC signal.
THROUGH: Outputs VITC signals.
VITC BLANK
Note:
• This setting is enabled only during VIDEO and SD SDI output.
• In EE mode, the VITC signal superimposed on the input signal is output as is.
Sets the position to insert the VITC signal.
• When set to 59.94 Hz:
LINE 10 to LINE 16 to LINE 20
• When set to 50 Hz:
LINE 7 to LINE 11 to LINE 22
VITC POS-1
Note:
• The same line as the "VITC POS-2" menu item cannot be selected.
• This setting is enabled only during VIDEO and SD SDI output.
• Pressing the [RESET] button will not restore the factory defaults.
Sets the position to insert the VITC signal.
• When set to 59.94 Hz:
LINE 10 to LINE 18 to LINE 20
• When set to 50 Hz:
LINE 7 to LINE 13 to LINE 22
VITC POS-2
Note:
• The same line as the "VITC POS-1" menu item cannot be selected.
• This setting is enabled only during VIDEO and SD SDI output.
• Pressing the [RESET] button will not restore the factory defaults.
Selects whether to superimpose the LTC information on HD SDI output.
HD EMBD LTC ON: Superimposes LTC.
OFF: Does not superimpose LTC.
Selects whether to superimpose the VITC information on HD SDI output.
HD EMBD VITC ON: Superimposes VITC.
OFF: Does not superimpose VITC.
Switches the phase of time code output from the TIME CODE OUT connector relative to ex-
ternal LTC input when "TCG MODE" is set to "EXT". (Only in EE mode)
TC OUTPUT REF
TC IN: Synchronized with the external time code input.
VIDEO OUT: Synchronized with the output video signal.
Settings and brief function description FREQ indications
59.94Hz 50Hz
59.94Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
59.94Hz 50Hz
89
Setup Menu: Menu List