Panasonic AJ-PD500P Operating Instructions Manual page 83

Item
After selecting the "FORMAT" menu item, format the P2 card in the P2 card slot to be spec-
ified or SD memory card in the SD memory card slot.
Note:
FORMAT
• When a CPS password is set, you can select "NORMAL" (normal unencrypted format)
or "CPS(ENCRYPT)" (encrypted format).
• Be sure to check the data before formatting since data erased by formatting cannot be
recovered.
Formats the storage device connected by USB.
TYPE S: Formats in the TYPE S format.
FORMAT
FAT: Formats in the FAT format.
(STORAGE)
Note:
This is enabled only when storage explorer or storage thumbnails.
Copies the selected clips to a P2 card in any P2 card slot or to a storage device.
Note:
COPY
• Do not turn off the power or remove/insert a card during copying. Doing so may result
in a bad clip. If a bad clip is created, delete it and perform copying again.
• Reconnect incomplete clips before copying.
Exports (writes) the data by card from P2 cards or SD memory cards to a storage device or
the LAN.
EXPORT
ALL SLOT, SLOT1 to SLOT4: Exports the data from P2 cards to a storage device.
SDCARD: Exports the data from SD memory cards to the LAN.
Imports (writes back) clips and other data by card from a storage device or the LAN to P2
cards or SD memory cards.
Note:
IMPORT
• This is enabled only for TYPE S storage devices.
• Data cannot be written back to a P2 card that does not have the same model number
as the original P2 card.
• This is displayed only when storage explorer or FTP explorer.
Repairs clips indicated by the bad clip indicator (
a sudden power outage during recording.
REPAIR Note:
Some clips may be so badly damaged they cannot be repaired. Bad clips that are beyond
repair are indicated by a red indicator (
Use this reconnection function to rejoin continuous clips that span across multiple P2 cards
but are not recognized as continuous clips and are indicated by the incomplete clip indica-
tor ( ).
Note:
• Incomplete clips occur under the following conditions.
RE-CONNECT
- When the segments of a continuous clip that are recorded on multiple P2 cards are
copied separately for each P2 card.
- When the segments of a continuous clip that are recorded on multiple cards are cop-
ied separately for each card to a storage device and then written back to the P2 cards.
• When some but not all the clip segments in a clip that consists of three or more clip seg-
ments are reconnected, the incomplete clip mark indicator (
EXCH. Changes the clip thumbnail to an image at any text memo position. This function can be ex-
THUMBNAIL ecuted when a text memo clip is displayed.
Switches to a screen that shows various information on storage device or LAN.
EXPLORE STORAGE: Switches to a screen that shows various information on storage device.
LAN: Switches to a screen that show various information on the LAN.
Selecting this menu item from the card status screen displays the soft keyboard for entering
the CPS password. Enter a password and select "OK" to set the CPS password on the unit.
When authentication with the set CPS password is successful, the "AUTHENTICATED SUC-
AUTHENTICATE
CESSFULLY!" message appears.
When authentication with the set CPS password fails, a warning message (➝ page 111) ap-
pears.
Settings and brief function description
) that were damaged by, for example,
).
FREQ indications
59.94Hz
59.94Hz
59.94Hz
59.94Hz
59.94Hz
59.94Hz
59.94Hz
) will remain displayed.
59.94Hz
59.94Hz
59.94Hz
Setup Menu: Menu List
50Hz
50Hz
50Hz
50Hz
50Hz
50Hz
50Hz
50Hz
50Hz
50Hz
83