Panasonic AJ-PD500P Operating Instructions Manual page 19

15.
PARALLEL REMOTE connector
This is a 15-pin parallel remote connector.
The assignment for each port can be selected in the "PAR-
ALLEL PORT PORT1-7 PORT 9-14" (➝ page 100 and
page 101) menu item.
Pin Port Name
No.
1 PORT1
2 PORT2
3 PORT3
4 PORT4
5 PORT5
6 PORT6
7 PORT7
8 +5 V Output
(+180 mA max.)
9 PORT9
10 PORT10
11 PORT11
12 PORT12
13 PORT13
14 PORT14
15 GND
Note:
• Supply TTL-level, active LOW electrical signals with an edge
of 100 msec or higher as input signals.
• A maximum open collector and sink current of 6 mA is out-
put as an output signal.
• Use a shielded cable to connect to this connector.
16.
Fan
This fan is for cooling the unit. Install the unit where the
ventilation holes will not be blocked.
Note:
If the fan is stopped while the power is on, the "FAN
STOPPED" warning is displayed. The unit will operate even if
the fan is stopped. However, please stop using the unit imme-
diately.
Function
Command input port 1
Command input port 2
Command input port 3
Command input port 4
Command input port 5
Command input port 6
Command input port 7
Status output port 1
Status output port 2
Status output port 3
Status output port 4
Status output port 5
Status output port 6
GND
Control Reference Guide: I/O Connectors
19