Table of Contents
Advertisement
AVCHD Playback Mode
Using an Optional AVCHD Board
What is AVCHD?
AVCHD is a standard for the recording and playback of high-definition video. Video is compressed in MPEG-4 AVC/H.264 and
audio is recorded in Dolby Digital or linear PCM.
Note:
• The unit can play back recorded clips that conform to the AVCHD standard or AVCHD Ver.2 standard (AVCHD Progressive).
• SD memory cards can only be used with the system frequency set at the time of formatting.
[Video compatibility]
• AVCHD video can only be used with AVCHD compatible devices. For details, refer to the operating instructions for your device.
SD/SDHC/SDXC Memory Cards
The following SD cards can be used for AVCHD playback with
this AVCHD option.
Card type
SD memory cards
SDHC memory cards
SDXC memory cards
Note:
• Please note that a miniSD, miniSDHC, microSD, microSDHC, or mi-
croSDXC memory card will not operate normally when in AVCHD play-
back mode, even if the dedicated adapter is attached.
• For the latest information not available in the Operating Instruc-
tions, visit the support page on the Panasonic website.
(➝ "Website URL" page 8)
• The unit supports SD memory cards formatted in the FAT12 and
FAT16 formats, SDHC memory cards formatted in the FAT32 for-
mat, and SDXC memory cards formatted in the exFAT format
that are compliant with the SD standard.
• SDHC memory cards of 4 GB or more without the SDHC logo
and SDXC memory cards of 48 GB or more without the SDXC
logo are not compliant with the SD standard.
• MultiMediaCards cannot be used.
SD memory card slots and access lamps
When an SD memory card is inserted in the SD memory card
slot of the unit, the recorded clips can be displayed as thumb-
nails and played back.
Note:
Before playing back the recorded clips, be sure to close the cov-
er of the SD memory card slot.
Size
32 MB to 2 GB
4 GB to 32 GB
Over 32 GB to 64 GB
Access lamps
Lit orange:
Reading possible.
Flashing orange
Recognizing or determining whether defective
(fast):
Flashing orange
Being accessed
(slow):
Off:
Reading not possible, no card is inserted, unfor-
matted, unsupported card inserted, or write-
protected
SD memory card protection
To prevent the accidental deletion of data recorded on the SD
memory card, set the write-protect switch on the SD-memory
card to "LOCK".
Removing SD memory cards
1
Check that the SD memory card access lamp is not
flashing.
2
Press the center of the SD memory card and then re-
move it after it bounces back by pulling it straight out.
Note:
Be sure to remove an SD memory card when the access lamp
is not flashing.
Removing an SD memory card when the access lamp is flash-
ing may damage the SD memory card or card slot.
AVCHD Playback Mode: Using an Optional AVCHD Board
65
Advertisement
Table of Contents
