Samsung SNP-5300 User Manual page 88

setup screen
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the
<network (
2. Click <QoS>.
3. Enter an IP address to which you will
apply QoS.
The default prefix for IPv4 is 32;
`
M
For DSCP, the default is set to 63.
4. Select an IP address to which you will
apply QoS.
Only the selected IPs can be prioritized.
5. When done, click [apply (
Snmp
With the SNMP protocols, you can allow the system or network admin to monitor the
network devices on a remote site, and configure the environment settings.
1. From the Setup menu, select the
<network (
2. Click <Snmp>.
3. Specify the <Snmp>.
• Enable SNMP v1 : SNMP version 1
will be active.
• Enable SNMP v2c : SNMP version 2
will be active.
- Read Community : Provide the
name of the read community where you can access to the SNMP information.
The default name is <public>.
- Write Community : Provide the name of the write community where you can
access to the SNMP information. The default name is <write>.
88_ setup screen
)> tab.
)].
)> tab.