Table of Contents
Advertisement
setup screen
network disconnect
This can be set to generate an event signal when the physical network connection is cut
off.
1. From the Setup menu, select the
<event (
2. Click <network disconnect>.
3. Specify the use of "Network
disconnect".
4. Specify the activation time and
activation condition.
For more information about <Activation
`
time> and <Action>, refer to "Alarm input".
(page 92)
5. When done, click [apply (
audio detection
You can set to detect sound over the specified level and trigger an event accordingly.
1. From the Setup menu, select the
<event (
2. Click <audio detection>.
3. Set whether or not to <enable>.
4. Set the audio detection's sound level.
The lower the level, the smaller the
sound change is detected.
The audio detection level is designed
`
M
to normalize the input data to a value
between 0 and 100 and detect the signal
larger than threshold level. It is unrelated
to the decibel (dB) level.
5. Specify the activation time and activation
condition.
For more information about < Activation
`
time > and < Action > , refer to "Alarm input". (page 92)
6. When done, click [apply (
If detected audio level is too low, set the audio input gain to a higher level in <Audio setup>.
`
M
100_ setup screen
)> tab.
)> tab.
)].
)].
Hide quick links:
Advertisement
Table of Contents
