Peripheral Devices; Activation Of A Serial Interface Rs 232 - QUORION QMP 3000 User Manual

13. Peripheral Devices

13.1 Activation of a Serial Interface RS 232

Your Cash Register can be equipped with up to 6 interfaces.
Location of interfaces (rear view)
RS 232
RS 232
RS 232
Each of the interfaces can be used after the activation. However, you may choose any in-
terface for a peripheral device once it has been activated. You may program the Identifica-
tion Number of the peripheral devices to be used. Note that the interface RS 485 is re-
served for a Cash Register network. For the Scanner use only the interface named
SCANNER because this connector is equipped with the separate power supply (5 +) for
the Scanner.
Technical Modification
This cash register contains the new software release 050415 with actualized interface drivers.
Please note, that the interfaces of the cash register now are numbered straight from 1 to 4. The old
numbering 1, 2, 5, 6 is not valid any longer!
If you are using pre-programmed customer configurations to install the cash register, it is
necessary to change the concerning PARAMETERS for the interface port numbers.
COM 4 COM 3
COM 2 COM 1
Picture 1: Interfaces of the cash register QMP 3000 (rear view) without QMP3396
COM 1 COM 2
COM 3 COM 4
Picture 2: Interfaces of the cash register QMP 3396 (rear view)
485
RS 232
RS
RS 232
485
in
RS 232
RS 232
49
RS RS RS 232
485
in out
RS 232 RS 232
RS
RS RS
485
232 232
out
RS 232