NEC LL009F User Manual page 91

(4) Network setup window
[Configure Loader] - [Network]
Function
This window is used to set up network connections.
Information
<1> Refresh button
This indicates the current setup information of this page.
<2> Ethernet setting
Link speed:
The network's link speed can be set as "Auto", "10Base-T Full", "10Base-T Half",
"100Base-TX Full", or "100Base-TX Half".
<3> TCP/IP Settings
Set time updating from the Time Server (NTP server) as enabled or disabled, and
specify information related to time settings.
Security:
When "Enable SSL for Web" is checked, SSL is used between the Autoloader
and the Applet to set encrypted communications.
IPv4 setting:
When "Use IPv4" is checked, the IPv4 protocol is used for communications.
-Obtain an IP address automatically (DHCP)
The IPv4 address, subnet mask, and gateway are retrieved from the DHCP
server and set automatically.
-Use static IP address
The IPv4 address, subnet mask, and gateway are set manually.
IPv6 setting:
When "Use IPv6" is checked, the IPv6 protocol is used for communications.
-Obtain an IP address automatically (DHCP)
Information is retrieved by DHCP, and the IPv6 address, prefix length, and
gateway are set automatically.
-Obtain an IP address automatically (Stateless Auto Config)
Information is retrieved from a router advertisement, and the IPv6 address,
prefix length, and gateway are set automatically.
-Use static IP address
The IPv6 address, prefix length, and gateway are set manually.
DNS Settings:
"Use DNS" is checked when using DNS settings.
<4> Submit button
This button is used to confirm settings. When the settings are completed, a normal
end message will appear.
- 91 -
Administrator