Table of Contents
Advertisement
4.1.1 LCD Screen
<1>
LCD screen
This screen displays menus and messages during various operations.
Up to two lines of 15 characters each can be displayed.
4.1.2 LED
The following four LEDs are included in the operation panel.
<2>
Power on indicator
This green LED is on when power is being supplied to the Autoloader.
<3>
Drive cleaning indicator
This orange LED is on when drive cleaning is required and when the
cleaning cartridge needs to be replaced.
<4>
Cartridge error indicator
This orange LED is on when a cartridge error has been detected.
<5>
Device error indicator
This orange LED.
Lighting:
Drive or Accessor error has been detected and when a diagnostic fault
has occurred.
Always check for messages displayed on the operation panel screen.
Blinking (0.8sec on , 0.8sec off):
Drive or Accessor warning has been detected.
Always check for messages displayed on the operation panel screen.
However, depending on a state, it may be displayed as "NO SENSE".
Blinking (2.7sec on , 0.5sec off):
The Autoloader is in offline state.
4.1.3 Buttons
The operation panel includes the following four buttons.
<6>
Up arrow/Number select button
This button is used to move the cursor up in a menu, and to select
numerical values.
<7>
Down arrow/Number select button
This button is used to move the cursor down in a menu, and to select
numerical values.
<8>
Cancel button
When this button is pressed, it is used to change menus or to cancel
number selection. It is also used to return from a submenu to the previous
(higher-level) menu.
<9>
Menu select/set button
When this button is pressed, the item displayed on the menu screen is
selected. It is also used to set a numerical value or character string that
has been selected.
Table 4-1 LCD Screen
Table 4-2 Operation Panel LEDs
Table 4-3 Operation Panel Buttons
- 36 -
Advertisement
Table of Contents
