Transferring Data From Another Scanner Or Pc; Cloning Your Scanner; Wired Programming - Radio Shack RPO-137 User Manual

(the first channel in bank 0), and program the fire
department frequencies starting with Channel 100
(the first channel in bank 1).

Transferring Data from Another Scanner or PC

You can clone your scanner by transferring the
programmed data to and from another PRO-137
scanner using a connecting cable. You can also
upload or download programmed data from a PC
through wired programming.

Cloning Your Scanner

You can clone all the frequencies programmed
in one PRO-137 to another PRO-137 using an
optional interface cable with 1/8-inch stereo
phone plugs on both ends (not supplied).
1. Make sure the scanners are turned off and
then plug the cable into each scanner's PC/IF
jack.
2. Turn on both scanners, then press E
master unit.
3. Press 1/PRI to stat cloning. Sending data...
appears on the master unit and Receiving data...
on the slave unit.
4. When the data transfer is completed, Finished
appears.
5. After the clone operation is complete, turn
the slave unit off, then remove the cable. Turn
the unit on again.
If you want to clone another scanner, press •CLR
/ L/OUT on the master unit, then repeat the steps
from 2.

Wired Programming

You can transfer programming data to your
scanner using your PC and an optional interface
1
of the
PGM