Using Signal Stalker I - Radio Shack RPO-137 User Manual

after the 10 log channels are fully stored with
frequencies, the oldest memory is deleted and
the new frequency is stored in that channel.
You can scan the log channels along with the
normal 1000 channels.
• The 10 log channels are located after Channel
999. You can access them by selecting S-00 to
S-09 or by manually entering channel numbers
1000 to 1009.
• You cannot program frequencies in the log
channels.
• You can lock out the log channels like normal
channels.
• The scanner stores signals found by the Signal
Stalker I even if the logging function is off. The
frequencies in the log channels are deleted
when the scanner is turned off.
4: Alert Beep
Set this function to 1: On if you want the
scanner to beep when Signal Stalker I finds a
frequency.
5: Alert Light
Set this function to 1: On if you want the
scanner to light when Signal Stalker I finds a
frequency.
6: Band Switch
Lets you select the Signal Stalker I band.
0 25-54
1 108-137
2 137-225
3 400-512
4 806-956
VHF Low Band
AIR Band
VHF High Band
UHF Band
800MHz Band
(without Cellular
Band)