Resetting The Scanner; Additional Information; Fcc Notice - Radio Shack RPO-137 User Manual

Resetting the Scanner

Caution: This procedure clears all the information
you have stored in the scanner. Before you reset
the scanner, try turning it off and on to see if it
begins working properly. Reset the scanner only
when you are sure it is not working properly.
1. Turn off the scanner. If you cannot turn off the
scanner, remove the battery and install again.
2. While holding down 2, 9 and SCAN, turn on
the scanner. Initializing...Please wait appears as
the scanner clears its memory.
Note: Do not turn off the scanner again until
Initializing...Please wait disappears. Otherwise,
the scanner might not clear its memory properly.

Additional Information

FCC Notice

Your scanner might cause radio or TV interference
even when it is operating properly. To determine
whether your scanner is causing the interference,
turn off your scanner. If the interference goes
away, your scanner is causing it. Try the following
methods to eliminate the interference:
• Move your scanner away from the receiver.
• Connect your scanner to an outlet that is on a
different electrical circuit from the receiver.
• Contact your local RadioShack store for help.
In some areas, mobile use of a scanner is
unlawful or requires a permit. Check the laws
in your area.
This device complies with Part 15 of the FCC
Rules. Operation is subject ot the following two
conditions: (1) This device may not cause harmful
interference. (2) This device must accept any
interference received, including interference that
may cause undesired operation.