Note: At least one bank needs to be entered.
If you disable all the banks, the error tone
beeps.
5. Rotate the knob to search down or up.
6. When the scanner stops on a transmission,
quickly press SRCH/PSE to stop searching to
listen to the transmission. *PAUSE* appears.
7. To release the pause and continue searching,
press SRCH/PSE.
Note: To step through the frequencies while
*PAUSE* appears, rotate the knob.
Search Speeds
The scanner has two search speeds. Normal
Search (90 steps/second ) and hypersearch (270
steps/second). Hypersearch applies only to the 5
kHz step bands (25–54 MHz, 137–174 MHz, and
216–224.9950 MHz).
Storing Found Frequencies
To store frequencies:
1. Press E
PGM
bank list appears.
2. Rotate the knob to select the bank number
you want to store the frequency, then press
E
. The smallest empty channel number
PGM
and "0.0000" appears.
3. Rotate the knob to move to the channel
where you wish to store the frequency.
4. Press E
PGM
If you want to assign a car number and tag, see
step 8 of "Storing Known Frequencies Into
Channels."
when you find a frequency. The
to enter the frequency.