Plug-In And Boot Up; Figure 15- Connect Ac Adapters - Network Technologies ST-C5USBV-300M Installation And Operation Manual

Plug-in and Boot Up

1. Plug the power cord(s) from the monitor(s) into power outlet(s).
2. Connect the AC adapter power connectors to the 9VDC ports on the Remote and Local Units. (AC adapter shown in Fig. 9)
3. Plug the AC adapters into power outlets. The "Power" LED (Green) on the CAT5 connector of each unit should illuminate,
indicating that a proper power connection has been made.
4. Turn ON the CPU and monitor(s). The CPU and monitor(s) should each react as if they were directly connected to each
other. The yellow communication LEDs on the Remote and Local Units (see Fig. 8) should blink indicating there is proper
communication between them.
Note: A loss of signal (blank screen) may be
experienced for an instant during the auto-
compensation process after powering-up (ST-
C5USBVA model only). This may also occur if the
XTENDEX senses a loss of or weak signal connection
in the CAT5 cable.
USER
CPU
L
0
C
A
L
U
N
I
9V
NTI
R 1.5 A T
1275 Danner Dr
Aurora, OH 44202
Tel:330- 562 - 7070
Fax:330- 56 2- 1999
www.networktechi nc.com
ST-C5U SBVA- 30 0M
ST-C5USBVA-300M
(Local Unit-Rearview)

Figure 15- Connect AC adapters

13
ST-C5USBV-300
Remote Unit
USB XTENDEX
Inc Technologies Network
NTI
R
-
+
(Rear View)
Barrel
Power Connector
9VDC @ 1.0A OUTPUT
(Outside
barrel)
2.1 mm x 5.5 mm Female
9 VDC
Adapter
ADAPTER
(Inside
barrel)