Table of Contents
Advertisement
MAC Mode
MAC Mode enables the user to connect the Local Unit to a MAC CPU. MAC Mode configures the Local Unit for passing mouse
information to the MAC CPU. This is useful when the user wants to use mouse drivers provided by the mouse vendor, which
allows the use of programmable functions for each mouse button. The Local Unit can be configured whenever necessary.
NOTE: When the port is connected to a PC or SUN CPU, MAC Mode should be OFF (the default setting).
To do this;
1.
Enter Command Mode. (Simultaneously press the left and right <Shift> keys on the keyboard connected to the Remote
Unit. The keyboard LEDs will illuminate. )
2.
If a MAC CPU is connected, press the <M> key. The keyboard LEDs will momentarily flash and the "MAC" LED on the
Remote Unit will illuminate to indicate MAC Mode is ON. (See Fig. 10)
3.
To reconnect the XTENDEX to a SUN or Windows CPU (the default setting) , press the <W> key and the "MAC" LED will
go OFF.
After setting, the configuration is stored in memory and will be retrieved whenever the XTENDEX is powered ON.
Note: MAC Mode can only be enabled from the keyboard connected to the Remote Unit.
DDC SUPPORT
DDC information allows the CPU to automatically detect the video capability of your monitor. The DDC information is updated
automatically at initial power-ON of the ST-C5USBV-300 Extender or whenever a different monitor is connected to the Extender.
DDC is only supported for the monitor connected to the Local Extender and it is recommended that the monitor connected to the
remote be the same model.
the DDC information.
ST-C5USBV-300
Remote Unit
(Rear View)
XTENDEX
USB
Inc
Technologies
NTI
R
MAC port configuration LED
Figure 16- MAC LED
The Local Extender and the monitor must both be powered ON prior to the CPU in order to update
Network
-
+
15
Advertisement
Table of Contents
