Using The Front Panel Leds For Troubleshooting; Using The Feed/Pause Button - Intermec EasyCoder 4420 User Manual

EasyCoder 4420/4440 Bar Code Label Printer User's Manual

Using the Front Panel LEDs for Troubleshooting

Over-Temperature If the printer overheats, the Alert LED flashes and the printer
stops. Do not try to troubleshoot or adjust the printer—just allow it enough time to cool
down and it will resume operation on its own. You should only encounter this problem
after extended print jobs.
Media or System Faults If the Empty/Pause or the Alert LED remains on, the printer
is experiencing a media or system fault. See Chapter 4, "Troubleshooting the Printer,"
for help in correcting the problem.

Using the Feed/Pause Button

The Feed/Pause button, located on the front panel of the 4420 or 4440 printer, performs
several functions depending on the mode of the printer.
Printer Mode
Idle
Printing
Turned on for the
first time
1-6
You Want To
Feed out one label or a
minimum specified amount
of media.
Continuously feed media.
Take the printer offline.
Pause the printer.
Cancel the current print
job.
Print the hardware
configuration test label.
What to Do
Press and release the Feed/Pause button.
Press and hold the Feed/Pause button. When
you release the button, the media stops
feeding.
Press the Feed/Pause button twice. Press the
button again to bring the printer online.
Press and release the Feed/Pause button. Press
and release the button again to resume
printing.
Press and hold the Feed/Pause button until the
printer stops printing.
Press and hold the Feed/Pause button. See
"Printing the Hardware Configuration Test
Label" later in this chapter.