Using Test And Service Mode Procedures - Intermec EasyCoder 4420 User Manual

This chapter explains the different procedures you can perform while the 4420 or 4440
printer is in Test and Service mode. Use Test and Service mode on the printer to print
test labels, perform special procedures such as cloning, and change some
configuration commands.

Using Test and Service Mode Procedures

When you press the Feed/Pause button, the current function pauses and the printer
enters Test and Service mode and executes all Test and Service mode procedures. The
printer remains in Test and Service mode until you turn off the power and reset the DIP
switches.
To enter Test and Service mode
1. Turn off the printer.
2. Press and hold the Feed/Pause button while turning on the power.
3. Set the DIP switches to the test or service function you wish to perform. See the
4. Press the Feed/Pause button. The test begins immediately.
5. If you want to perform another function, change the DIP switch settings and press
The function the printer is currently executing terminates, and the printer performs the
new function.
To exit Test and Service mode
1. Turn off the printer.
2. Reset the DIP switches to their original settings.
3. Turn on the printer.
Use the information in the following table to set the DIP switches for the appropriate
Test and Service mode function you want to perform.
The printer prints out a hardware configuration label and then enters Data Line
Print mode.
following table for a list of the DIP switch settings.
the Feed/Pause button.
C d 39
Using Test and Service Mode
6
6-3