Ethernet Connection; Ethernet Connection - Standard; Ethernet Connection - Wireless Option - Klark Teknik DN9848E Operator's Manual

Remote Control Setup

9.3. Ethernet Connection

For familiarisation purposes, a basic Ethernet connection may be made to a single unit by connecting
the Ethernet cable to either of the unit's rear panel Ethernet sockets and to the network socket on the
laptop PC or wireless access point (wireless option).
Note For Ethernet connectivity, the HELIX DN9848E units must be operating V4.01 (or later) host
code.
9.3.1 Ethernet connection – standard
Alternatively, you can set up a system involving multiple units. One end of the Ethernet cable is
connected to the network socket of the laptop/PC. The other end is either connected to an Ethernet
socket on one of the HELIX DN9848E units (daisy chain), or an Ethernet switch or hub, depending on
system configuration.
9.3.2 Ethernet connection – wireless option
The system set-up for the wireless option Ethernet connection is via an Ethernet cable. One end is
connected to the network socket of the wireless access point. The other end is connected to either an
Ethernet socket on one of the HELIX DN9848E units (daisy chain), or an Ethernet switch or hub,
depending on system configuration. This system is operated remotely from a tablet or laptop PC.
34