Front Panel - Klark Teknik DN9848E Operator's Manual

Controls, Connectors, Indicators
2. F P
RONT ANEL
1
6
1 Input channels A-D
MENU ACCESS
Buttons A-D
Signal Level
Meters A - D
2 RECALL button
3 Alphanumeric display
4 HOME (SET UP) button
5 Output channels 1 - 8
MENU ACCESS
Buttons 1-8
Signal Level
Meters 1 - 8
Output level and
mute control
6 DATA ENTRY control
knobs
7 STORE button
8 PC port
9 POWER button
2 3
7
Press to access and step through the menu pages for the
respective input. The available pages depend on the current
security setting. The button is lit when active.
9-segment signal meters for monitoring signal level
(compressor headroom and gain reduction) and clip on the
respective channels.
Press to access the Recall menu page from which a User,
System or Backup memory can be selected for recall.
Displays menu pages for viewing/defining parameter values.
Values are adjusted via the DATA ENTRY control knobs.
Press to exit current menu page and return to default Home
page. Press and hold for one second to access Set Up menu,
then press to step through Set Up pages.
As for input channels.
11-segment signal meters for monitoring signal level
(compressor headroom and gain reduction – reads relative
to limiter threshold) and clip on the respective channels.
Potentiometer control for fine-tuning/muting of output level.
Provides relative adjustment from zero level, which is the
level set in the output menu. Turn control to
increase/decrease level or press to mute. Red ring
illuminates when mute is active.
Used to set parameter values on menu pages (see
Section 4.1).
Press to access the Store menu page for storing User or
System memories.
8-pin mini-DIN socket for connecting to an RS-232 serial
port on a PC or other remote control device. (Ethercon
connectors are provided on the rear panel for remote control
via Ethernet.)
Press to switch the unit on or off.
4
8
4
5
9