Setting Output Parameters; Naming The Output Channel And Matrix Mixing - Klark Teknik DN9848E Operator's Manual

6.2. Setting Output Parameters

Signal processing for each output channel is programmed independently via the separate Output
menu associated with each channel. The signal processing parameters are described below in menu
order.
To access the Output menu pages for a particular channel
Press its blue MENU ACCESS button (1 – 8) to switch to its menu.
Press the button repeatedly to step through the pages in turn. Note that, after the last page,
the next button press will cycle the menu back to the first page.
To skip across to the same parameter on another output, press its MENU ACCESS button.
6.2.2 Naming the Output Channel and Matrix Mixing (Page 1)
Each output channel can be allocated a name up to eight characters long, which will be shown in the
first page of the menu for easy reference. The default names are "Output 1", "Output 2", etc. Names
are retained after power down and are included in stored settings.
Each output of the DN9848E can be sourced from a mix of the input channels. The level of the source
inputs can be set to between 0.0dB and –40.0dB or switched off.
To enter a name
1
Turn the left DATA ENTRY control knob
clockwise to access the Output Name
menu page.
2
Use the centre control knob to move the
cursor right or left, and the right control
knob to select the letter, number or
symbol.
3
On completion, turn the left control knob
anti-clockwise to go back to the main
page. The new name is now shown to
the left of the menu page.
To set the source input channel and adjust the level
1
Using the centre DATA ENTRY control
knob, select source input channel,
that is, A, B C or D.
2
Turn the right control knob to select
the level of the source input, or
switch level off.
3
On completion, press the next
output channel MENU ACCESS button
to go to the next menu page.
Output Channels
User-defined channel name
13
User-defined output channel
source and level