Gang Mode Setup - Klark Teknik DN9848E Operator's Manual

7.3. Gang Mode Setup (Page 2)
This option is used to link multiple input channels or output channels together so that a change on
one channel will be made to all channels in the gang. When a gang is created, the settings from the
source channel are copied to the destination channel(s) so that all ganged channels inherit the same
parameter values. From hereon, any changes to a ganged channel are carried out on the other
channels on an absolute basis, with the exception of input and output names.
Notes A channel may only be part of one gang.
Only channels of a similar type may be ganged, that is, you cannot gang
input channels to output channels or vice versa.
Ganging is a feature of stand alone unit operation only and is not
compatible with the grouping facility offered in the Elgar 9848E Remote
Control Software add-in. Therefore, ganging is only active when the unit
is put into Gang mode, see Section 7.2; channel ganging is disabled if
the unit is set to receive data on a remote comms channel.
To select channels for ganging
1
Step through the Set Up menu to the Gang Mode Setup menu page.
2
Press the blue MENU ACCESS button on
the input (A - D) or output (1 – 8)
channel that you wish to be the source
channel for the gang.
Notes The MENU ACCESS button flashes to indicate that channel is selected as the
source.
Press the HOME button at any point to exit the gang mode and return to
the Home page.
3
Now press the blue MENU
ACCESS buttons on the
channels you wish to gang;
the buttons flash as they are
selected, and press the STORE
button.
Note If the source channel is an input, you may only select input channels as
part of the gang. Similarly, if the source channel is an output, only
output channels may be selected.
4
Finally, press the STORE button again
to confirm the operation. All
parameters from the source channel
are copied to the destination channels
with the exception of the input and
output channel names, and the channels are prepared for ganging.
To activate channel ganging, you must select the Gang mode as described in Section 7.2. With the
unit switched to gang mode, any changes to a ganged channel are carried out on the other channels
on an absolute basis. Also notice that when you select the blue MENU ACCESS button of a ganged
channel in normal operation, the MENU ACCESS buttons on the ganged channels illuminate to show that
they are part of the gang.
Security and Other Set Up Options
23