Gain And Delay; Parametric Equalisation (Pages 2 To 13) - Klark Teknik DN9848E Operator's Manual

Input Channels
5.2.3 Gain and Delay (Page 1)
Gain and delay are also set in the first page of the channel's
menu, providing easy access for quick adjustment during set
up or performance. Note that the delay can be specified in
terms of time or distance, as preferred. The unit of
measurement is changed in the Set Up menu (see
Section 7.9).
To set the delay
Turn the centre DATA ENTRY control knob slowly for step increments, or sharply to leap to the
bottom/top of the range (two or three sharp turns should cover the whole range). When the
delay is set for time the overall range is 0 to 1.00s, with steps of approximately 20.8µs
between 0 to 1ms and steps of 0.02ms between 1ms to 1s. When the delay is set for metres,
the overall range is 0 to 343.53 m in steps of 0.1 m and for imperial (feet and inches) the
overall range is 0' 0" to 1127' 0" in steps of 1".
To adjust the gain
Turn the right DATA ENTRY control knob. The range is –40dB to +12dB in steps of 0.1dB, with
an OFF position just 'below' –40dB. Setting the gain to OFF will mute the input signal.
5.2.4

Parametric Equalisation (Pages 2 to 13)

The DN9848E provides 12 parametric equalisation stages
on each input channel, for equalising the input signal in
respect of room/venue characteristics. Each stage can be
used across the full range from 20Hz to 20kHz and is set
independently via its own menu page.
To set a PEQ
1
Set a centre frequency (21 steps per octave) and bandwidth (0.08 to 3 Oct) for the PEQ
section, using the left and centre DATA ENTRY control knobs, respectively.
2
Turn the right control knob to set an attention/boost level in the range -18dB to +6dB.
PEQ sections that are not needed in the set up should be set to 0dB attention/boost.
Delays can be set in seconds,
10
metres or feet and inches