Security Settings (Pages 3 And 4); Front Panel Lock - Klark Teknik DN9848E Operator's Manual

Security and Other Set Up Options
To remove a channel(s) from a gang
This procedure is the same for input channels and output channels. In the following example, inputs
A, C and D are initially ganged.
1
Step through the Set Up menu to the Gang Mode Setup
menu page.
2
Press the blue MENU ACCESS button on any of the
channels within the gang, for example, input
channel A. The MENU ACCESS buttons flash to
indicate channels in the gang.
3
Press the blue MENU ACCESS button on the channel
you wish to remove from the gang, for example,
channel D. The blue MENU ACCESS button will
extinguish to show that it has been deselected and
removed from the gang.
4
Repeat Step 3 for any other channel you wish to remove from the gang. To completely
dissolve the gang, press all flashing MENU ACCESS buttons to extinguish them.
5
Press the STORE button twice to complete the operation.

7.4. Security Settings (Pages 3 and 4)

7.4.1 Front Panel Lock (Page 3)
This option is used to set a password and lock out all, or nearly all, of the front panel controls to
protect settings from tampering by unauthorised personnel. Five levels of Panel Lock are possible:
• Unlocked – All controls available.
• Lock + Recall – This leaves
the Recall button active so that
saved memories can be still be
recalled.
• Lock + Recall + Mute - As
above, but also leaves the Mute
controls active.
• Lock + Mutes – Leaves the
Mute controls only active.
• Locked – Imposes a full
lockout on the front panel
controls.
In all cases, limited Set Up menu options remain available, namely the Comms Channel, Panel Unlock
pages and Power Up pages.
24