Channel Copying - Klark Teknik DN9848E Operator's Manual

Output Channels

6.5. Channel Copying

Parameters from a source channel may be copied to one or more destination channels using the
channel copy function. Note that parameters may only be copied between channels of a similar type,
that is, you cannot copy input channels to output channels or vice versa.
To copy a channel's parameters
1
Press and hold the blue MENU ACCESS
button on the source input (A - D) or
output (1 – 8) channel for more than
three seconds. This puts the unit into
copy mode, as indicated on the display,
and selects that channel as the source for the copy.
Note The MENU ACCESS button flashes to indicate that channel is selected as the
source.
Press the HOME button at any point to exit copy mode and return to the
Home page.
2
Now press the blue MENU
ACCESS buttons on the
destination channels. The
buttons illuminate as they are
selected.
Note If the source channel is an input, you may only select input channels as
destinations. Similarly, if the source channel is an output, only output
channels may be selected as destinations.
3
Press the flashing blue MENU ACCESS
button on the source channel again, and
the display updates to request
confirmation for the copy.
4
Press the STORE button to confirm the
copy, or press HOME to exit the copy
mode without completing the
operation.
20