Storing And Recalling Settings - Klark Teknik DN9848E Operator's Manual

8. S
TORING AND
The DN9848E System Controller has the following memory facilities:
• 32 lockable System memories, designated as S01 to S32, for storing standard set-ups in
battery-backed-up SRAM. These memories may be locked to prevent accidental changes to
common set-ups using the System Protect function as described in Section 7.4.2. They may
also be backed up into flash memory, using the Backup System function as described in
Section 7.8, to provide system memory recovery in the event of power loss and battery
failure.
• Five free access User memories, designated as U01 to U05, for storing a series of set ups for
the current show.
To store settings in either a user or system memory
1
Press the black STORE button to
access the Store menu.
2
Select a User memory location
(U01 –U05) using the left DATA
ENTRY control knob, or a System
memory location (S01 – S32)
using centre control.
3
Press STORE to accept the memory
location and move on.
Since a memory location is now active, you should only press STORE if you wish to accept and
Note
continue the storing process. Otherwise, press HOME to abort.
4
The current working memory name is displayed (as
defined in the Set Up menu). To change the name
before storing, use the left DATA ENTRY control knob to
move the cursor right or left, and the centre control
knob to select the letter, number or symbol.
5
Press STORE to confirm the action and return to the DN9848E Home page.
The DN9848E automatically checks the memory settings and displays a warning if any errors are
found. Where possible, it will also attempt to automatically correct the error.
To lock the 32 system memory locations see Section 7.4.2 System Protect.
To recall stored settings from memory
1
Press the black RECALL button to
access the Recall menu.
2
Select a User memory (U01 –
U05) using the left DATA ENTRY
control knob, or a System
memory (S01 – S32) or Backup
memory (B01-B32) using the
centre control.
3
Press RECALL to confirm the
action and return to the
DN9848E Home page.
The selected memory settings are recalled to the working memory.
Using the DN9848E Memories
R S
ECALLING ETTINGS
31