Connection Of Electrical Supply - Nu-Vu X5 Manual

RECEIPT AND INSTALATION
IMPORTANT: DO NOT CONNECT THIS UNIT IF YOUR POWER SOURCE DOES NOT
MATCH THE REQUIREMENTS AS LISTED ON THE UNIT LABEL!
This equipment must be installed and connected in accordance with all applicable federal, state, province, and/or
local electrical codes having jurisdiction using properly rated all pole mains protection and all pole mains
disconnect. All electrical connections must be made with COPPER WIRE ONLY in the correct gauge for the
application. The unit may be connected either through a cord, plug and receptacle-type connection or direct wiring
using flexible conduit. Allow enough slack in the wiring to allow for equipment to be moved during installation or
any required maintenance and servicing.
WARNING: ALL POWER MUST BE TURNED OFF AT THE ELECTRICAL SUPPLY WHILE
A. Check to determine that the power source is the same voltage and phase as that indicated on the label on
the side of the unit.
B. Attach the included Appliance Legs to the bottom of the unit. Each Leg stud screws into a threaded hole
in each corner of the base.
C. Position the unit where it is to be operated and adjust the Appliance Legs so the unit stands level and
®
solid. NU-VU
installed.
D. Set the Power Switch to the OFF position.
E. Connect your unit with the attached 250 volt/30 amp (Three Phase) or 250 volt/50 amp (Single Phase)
Power Cord to a 250 volt/30 amp (NEMA 15-30R) (Three Phase) or 250 volt/50 amp (NEMA 6-
50R)(Single Phase) receptacle. Allow enough slack in the Power Cord to allow for equipment to be
moved about during installation and any future servicing.
IMPORTANT: IN A THREE PHASE SYSTEM ANY WILD LEG (MORE THAN 120 VOLTS TO
GROUND) MUST ALWAYS BE CONNECTED TO L-2!
®
NU-VU FOOD SERVICE SYSTEMS
(906) 863-4401 ♦ (800) 338-9886
THIS UNIT IS BEING CONNECTED!
recommends a minimum 4" spacing all around the sides and back of the unit when
Sales Fax (906) 863-5889 ♦ Service Fax (906) 863-6322
X5 OWNER'S MANUAL
MENOMINEE MICHIGAN 49858-1029
2
page