7
Operating the VP-8x4AK
This section describes how to:
•
Use the IN and OUT buttons (see
•
Read the 7-segment displays (see
•
Confirm settings (see
•
Store and recall input/output configurations (see
•
Lock the front panel (see
•
Choose the audio-follow-video or the breakaway feature (see
•
Use the audio gain control (see
7.1
Switching an Input to an Output
To switch an input to an output:
1. Press the required OUT button.
The input under the selected output on the IN 7-segment display blinks.
2. Press an IN button to select the input to switch to the output.
The selected input number appears on the 7-segment display.
Incomplete operations on the VP-8x4AK timeout after 15 seconds
7.2
Understanding the 7-Segment Displays
The VP-8x4AK has two displays:
•
The STATUS 7-segment display
•
The REL. AUDIO LEVEL (dB) 7-segment display
7.2.1 The STATUS 7-Segment Display
During normal operation, the STATUS display shows which inputs are
switched to which outputs, as illustrated in
the display shows the video signal setup and in the AUDIO mode, it shows
the audio signal setup. In the AFV it shows both signals (see
Figure 12: 7-segment Display during Normal Operation
Immediately after switching on the power, the status display shows the
firmware version number. This display disappears after a few seconds,
replaced by the normal display.
Operating the VP-8x4AK
Section 7.1
Section 7.2
Section 7.3
)
Section 7.5
)
Section 7.7
)
)
Section 7.4
)
Figure
12. In the VIDEO mode,
)
Section 7.6
)
Section
7.6).
21