Hitachi J300U Series Instruction Manual page 125

[Setting method]
(1) Digital operator
FUNC
A 59
FUNC
A 59
(2) Remote operator
F-10
Initial display
RUN MODE
RUN
MODE
FS0000.00
0
2
RUN
FUNC
NOR
OEN
GOD
GOD
STR
MON
0.0Hz
A-13
Select 2 by A
tion.
Running mode selection
0: Normal running
1: Energy conservation running
2: Fuzzy most suitable acceleration and
deceleration running
When the running starts after the data is set, the
most suitable acceleration and deceleration
running is performed.
F-10 running mode selection is displayed. Dis-
play the RUN MODE screen and select "GOD".
Running mode selection
NOR: Normal running
OEN: Energy conservation running
GOD: Fuzzy most suitable acceleration and
deceleration running
When the running starts after the data is set, the
most suitable acceleration and deceleration
running is performed.
* When the running starts after the data is set,
the acceleration and deceleration time display
is as shown below. During the fuzzy most
suitable acceleration and deceleration running,
the acceleration and deceleration time display
in the monitor mode is invalid. (The time can
be set but the display is invalid. It becomes
valid once again during the normal running.)
running mode selec-
5 9