Hitachi J300U Series Instruction Manual page 70

Extension
function
code
A terminal function is allocated to each of the output intelligent terminals 11 and 12. When using
a function other than the standard set functions or changing the terminal order, set the function for
each terminal.
Arrary of codes and intelligent terminals
Code
C10 Output terminal setting 11
Output
C11 Output terminal setting 12
terminal
setting
Input terminal function list
11 and 12
Abbrevia-
Set value
0 FA1
RUN
1
2 OTQ
NOTE: The torque of the overtorque signal can be set by the remote operator. The initial
Setting method
Press the
The set values of the terminals which are set at present are displayed. Display the set value
of the terminal to be used from the function list indicated below by pressing the key
and
The display is returned to the code display and the terminal function is changed.
Precautions for terminal setting
Same terminals cannot be set between
When moving a terminal name to another terminal, set another terminal which is not to be
ued at the setting source before inputting the set value to the setting destination and then
select the terminal name which is to be set at the setting destination.
Function name
Function name
tion
Frequency arrival signal
Signal during running
Overtorque signal (Note)
values of motoring and regeneration are 100% torque. The overtorque signal can be
used only under the sensorless vector control.
key once for the terminal code to be set.
FUNC
2 and then press the
FUNC
Contents and display
Terminal Initial
rating plate setting
11 0
12 1
key.
FUNC
Enter the set value of the terminal name
to be used by pressing the keys
and
7-30
PCB terminal array
CM2
12
11
AL2
AL1
AL0
The setting method is the same
as that of the input terminals
to
and .
2
1
FUNC
.
.
1