Hitachi J300U Series Instruction Manual page 97

(Function mode 1)
Display
Function Function
sequence
No. name
6 F-05 Motor
Motor M setting
constant constant
Motor
J setting
constant
Motor
constant
Kp setting
Motor
constant
Ti setting
Motor
constant
KPP setting
7 F-06 Accelera-
Accelera- tion time
tion time setting
2-stage
acceleration
time setting
Curve
pattern
selection
for
acceleration
Accelera-
tion and
deceleration
curve
constant
selection
8 F-07 Decelera-
Decelera- tion time
tion time setting
2-stage
deceleration
time setting
Curve
pattern
selection
for
deceleration
Accelera-
tion and
deceleration
curve
constant
selection
(Function mode 2)
Initialization display
contents
AUX M 123.60 mH
2
AUX J 0.44 kgm
AUX Kp 002.00
AUX Ti 00100 ms
AUX KPP 001.00
ACC 1 0030.00 s
ACC 2 0015.00 s
ACC LINE L
ACC GAIN 02
DEC 1 0030.00 s
DEC 2 0015.00 s
DEC LINE L
DEC GAIN 02
12-6
Setting, change
Initialization
contents
Rated capacity 0 to 655.35
of each inverter
Rated capacity 0 to 655.35
of each inverter
2.0 0 to 100.00
100 ms 0 to 10000
1.0 0 to 100.00
30.00 s 0.01 to 3000
15.00 s 0.01 to 3000
L L (Linear),
S (S curve),
U (U curve),
RU (reverse
U curve)
2 (common to 1 to 10
acceleration
and
deceleration)
30.00 s 0.01 to 3000S
15.00 s 0.01 to 3000S
L L (Linear),
S (S curve),
U (U curve),
RU (reverse
U curve)
2 (common to 1 to 10
acceleration
and decelera-
tion)
Setting contents
• Primary self inductance per
phase.
• Motor and machine inertia
• Smaller: High response
• Larger: Low response
• Set this item after the
feedback option PCB is
installed.
• Set this item after the
feedback option PCB is
installed.
• When the fuzzy most
suitable acceleration and
deceleration (F-10) are set,
the time displayed here is
invalid, though it can be
set.
• The acceleration time can
be used when the input
terminal CH1 is shorted.
• For input terminal
selection, refer to F-34
input terminal.
• The curve pattern is set for
acceleration and
deceleration respectively.
• When the constant is set
for one of acceleration and
deceleration, it is common
to both acceleration and
deceleration.
• See appendix 4.
• When the fuzzy most
suitable acceleration and
deceleration (F-10) are set,
the time displayed here is
invalid, though it can be
set.
• The deceleration time can
be used when the input
terminal CH1 is shorted.
• For input terminal
selection, refer to F-34
input terminal.
• The curve pattern is set for
acceleration and decelera-
tion respectively.
• When the constant is set
for one of acceleration and
deceleration, it is common
to both acceleration and
deceleration.
• See appendix 4.