Lexmark XM1100 Series User Manual page 55

Additional printer setup
b
Double‑click the software installer package.
Wait for the installation dialog to appear.
If you are using the Software CD and the installation dialog does not appear, then do the following:
In Windows 8
From the Search charm type run, and then navigate to:
Apps list > Run > type D:\setup.exe > OK
In Windows 7 or earlier
1
Click or click Start, and then click Run.
2
In the Start Search or Run dialog, type D:\setup.exe.
3
Press Enter or click OK.
Note: D is the letter of your CD or DVD drive.
c
Click Install.
d
Follow the instructions on the computer screen.
e
Select Advanced, and then click Continue.
f
From the Configure Printer Connection dialog, select a port.
g
If the port is not in the list, then click Refresh or navigate to:
Add port > select a port type > enter the necessary information > OK
h
Click Continue > Finish.
3
Set the COM port parameters.
After installing the printer driver, set the serial parameters in the COM port assigned to the printer driver.
Note: Make sure the serial parameters in the COM port match the serial parameters you set in the printer.
a
Open Device Manager.
In Windows 8
From the Search charm type run, and then navigate to:
Apps list > Run > type devmgmt.msc > OK
In Windows 7 or earlier
1
Click or click Start, and then click Run.
2
In the Start Search or Run dialog, type devmgmt.msc.
3
Press Enter or click OK.
b
Double‑click Ports (COM & LPT) to expand the list of available ports.
c
Do either of the following:
•
Press and hold the COM port where you attached the serial cable to your computer (example: COM1).
•
Right‑click the COM port where you attached the serial cable to your computer (example: COM1).
d
Click Properties.
e
On the Port Settings tab, set the serial parameters to the same serial parameters set in the printer.
Check the serial heading of the menu settings page for the printer settings.
55