Table of Contents
Advertisement
NetDVR.book Page 24 Wednesday, May 12, 2004 4:06 PM
NetDVR | User's Guide | Configuring the NetDVR
3.6.4 PTZ
The 'PTZ' section sets up the drivers for a pan/
tilt/zoom control mechanism, if installed.
To install click the 'Setup' button and configure
the following:
•
Model: At present, NetDVR is supplied
with some protocols for specific models of
pan/tilt mechanisms (which can be selected
from the pull down menu).
•
Select communication protocol and enter
this is the appropriate fields:
•
Interface: NetDVR has two sets of interface pins: the RS232 interface and the RS485
(half-duplex) interface. Select the appropriate interface for which the pan/tilt/zoom
control receiver is connected to NetCam-DVRII.
•
Baud: Configures data transmission rate (from the pull-down list).
•
Parity: Checks data loss for transmission (from the pull-down list).
•
Stop bit: Configures stop bit for transmission (from the pull-down list).
•
Data bit: Configures data bit for transmission (from the pull-down list).
•
Address: This field identifies the base address of the pan/tilt/zoom (P/T/Z) control
receiver for the select video channel.
Note:
Settings for Bosch and Philips Autodome devices: Interface: RS232, Baud: 9600, Parity: None, Stopbit: 1,
Address: address of the PTZ device, and Databit: 8. The NetDVR may support up to four PTZ devices for four
separate channels. Use the RS232-to-bi-phase converter to connect and address the four devices.
Click the "Apply" button to upload the settings into the NetDVR.
Bosch Security Systems | 2004-01
24
Advertisement
Table of Contents
