Worker Sw Wsw) Setting And Printout - Brother DCP-7030 Service Manual

1.4.6 Worker Sw WSW) Setting and Printout

[ 1 ] Worker Switch Setting (Function code 10)
<Function>
The machine incorporates the following worker switch functions which may be activated with
the procedures using the control panel buttons. The worker switches have been set at the
factory in conformity to the communications standards and codes of each country. Do not
adjust them unless necessary. Some worker switches may not be applicable in some
versions. The worker switch data list indicates "Not used." for those inapplicable switches.
* Details of Worker switches
The details of the worker switches are described in
accessible selectors of the worker switches are shaded.
■ Worker Switches
WSW No.
WSW01
WSW02
WSW03
WSW04
WSW05
WSW06
WSW07
WSW08
WSW09
WSW10
WSW11
WSW12
WSW13
WSW14
WSW15
WSW16
WSW17
WSW18
WSW19
WSW20
WSW21
WSW22
WSW23
WSW24
WSW25
WSW26
WSW27
Dial pulse setting
Tone signal setting
PABX mode setting
TRANSFER facility setting
1st dial tone and busy tone detection
Redial/Pause button setting and 2nd dial tone detection
Dial tone setting 1
Dial tone setting 2
Protocol definition 1
Protocol definition 2
Busy tone setting
Signal detection condition setting
Modem setting
AUTO ANS facility setting
REDIAL facility setting
Function setting 1
Function setting 2
Function setting 3
Transmission speed setting
Overseas communications mode setting
TAD setting 1
ECM and call waiting caller ID
Communications setting
TAD setting 2
TAD setting 3
Function setting 4
Function setting 5
APPENDIX 1
Function
5-8
in which the user-
Refer to:
App. 1-3
App. 1-5
App. 1-6
App. 1-8
App. 1-9
App. 1-10
App. 1-12
App. 1-13
App. 1-14
App. 1-15
App. 1-16
App. 1-17
App. 1-18
App. 1-19
App. 1-20
App. 1-21
App. 1-22
App. 1-23
App. 1-24
App. 1-25
App. 1-26
App. 1-27
App. 1-28
App. 1-29
App. 1-30
App. 1-31
App. 1-32
Confidential