WeiderPro 30963.0 User Manual page 17

25. Route the Lat Cable (49) over a Thin Pulley (24)
and down through the Top Frame (4). Hold the
Thin Pulley inside the Top Frame. Insert an M10 x
80mm Bolt (84) through an M10 Washer (80), a
19mm Spacer (67), the Top Frame, and the Thin
Pulley.
26. Wrap the Lat Cable (49) under a 90mm Pulley
(48). Attach the Pulley, a Cable Trap (56), and two
Half Guards (55) at the second hole from the top
of the two Pulley Plates (60) with an M10 x 50mm
Bolt (97) and an M10 Nylon Locknut (77). Make
sure that the Cable Trap and the Half Guards
are oriented as shown.
27. Route the Lat Cable (49) up through the Top
Frame (4) and wrap the Cable over a Thin Pulley
(24). Pull the M10 x 80mm Bolt (84) out of the Top
Frame until it is flush with the first Thin Pulley
from step 24. Do not remove the Bolt complete-
ly from the Top Frame.
Hold the second Thin Pulley (24) inside the Top
Frame (4) and attach it with the M10 x 80mm Bolt
(84), a 19mm Spacer (67), an M10 Washer (80),
and an M10 Nylon Locknut (77).
25
49
26
27
17
24
84
4
80
67
77
49
55
55
60
56 48
97
60
24
49
80
84
113
67
77