Cable Assembly - WeiderPro 30963.0 User Manual

Cable Assembly

19. See the CABLE DIAGRAMS on page 28 to identi-
fy the cables as you assemble them.
Identify the Butterfly Cable (50). Grease an
M8 x 22mm Shoulder Bolt (90). Attach the Cable to
the Left Butterfly Bracket (28) with the Shoulder Bolt
and an M8 Nylon Locknut (78). Make sure that the
flat edge of the Cable is against the Butterfly
Arm. Do not overtighten the Shoulder Bolt; the
Cable must pivot freely.
20. Wrap the Butterfly Cable (50) over a "V"-pulley
(47). Attach the "V"-pulley, a Long Cable Trap
(57), an M10 Washer (80), and two Guards (54)
to the Upright (2) with an M10 x 60mm Bolt (79)
and an M10 Nylon Locknut (77).
21. Wrap the Butterfly Cable (50) under a 90mm
Pulley (48). Attach the Pulley and two Half Guards
(55) to the Double "U"-bracket (61) with an M10 x
45mm Bolt (86) and an M10 Nylon Locknut (77).
Make sure that the Half Guards are oriented as
shown.
19
Flat Edge
20
21
86
15
Grease
90
50
28
78
77
54 50
2
57
54
80
47
50
48 77
55
61
55
79